WATERROWER SERVICE

      Sensor Disk Replacement- Download
      Instruction

      Step 1- Remove the Handle
      from the handle rests and place the handle in the full forward position as
      shown.

      Step 2- Stand the
      WaterRower upright and disconnect the bungee as shown.

      Step 3- Lay
      the WaterRower down. Remove the tie rods and JCB bolts connecting the top
      deck to the tank assembly as shown.

      Step 4-
      Remove the top deck assembly as shown, being careful not to dislodge the
      guide pulleys. You may have to disconnect the tacho pulley. Disconnect the
      tacho motor plug.

      Step 5-
      Remove the Sensor Disk as shown.

      Step 6-
      Replace the Sensor Disk as shown.

      Step 7-
      Replace the top deck as shown.

      Step 8- 
      Replace the JCB bolts and tie rods connecting the top deck to the tank 
      assembly as shown. Ensure that the tie rod cross dowel slots are aligned 
      with the tie rod. You may utilize a screw driver to assist this.

      Step 9- Stand
      the WaterRower upright and connect the recoil belt to the bungee as shown.

      Note: If the recoil belt
      buckle and D-ring have been removed it will be necessary to refit them
      before Step 9 may be completed. Refer to the  
      Recoil
      Buckle Replacement Instruction for details