WATERROWER SERVICE

      S4 Monitor Board Replacement- 
      Download
      Instruction

        Step 1- Remove Battery 
        cover screws

        Step 2- 
        Remove battery cover

        Step 3- 
        Remove batteries

      Step 4- Remove screws (4)
      fastening the monitor facia to the monitor backplate as shown.

      Step 5- Remove the Board
      Assembly as shown.

      Step 6-
      Disconnect the Sensor Wiring Connector as shown.

      Step 7-
      Replace monitor  board as shown. Be careful to ensure that you
      place the Sensor Wiring Connector correctly. The connector should be 
      orientated so that the red wire is toward the outside edge of the board.

      Step 8-
      Replace Monitor Board assembly as shown.

      Step 9-
      Replace screws (4) fastening the Monitor Board Assembly to the Monitor 
      Housing as
      shown.

        Step 10- 
        Replace batteries

        Step 11- 
        Replace battery cover

        Step 12- 
        Replace battery cover screws